Prowler Technical Info

• Concealed air filter

• Easy replacement and cleaning
• Added Pre-filter screen for improved filtering over factory setup

• More than double the HP to the rear wheels

• No Engine work needed

• No need to break seal on engine and install a head shim.
• Runs on 91 octane pump fuel @ 6 PSI boost above 4K feet.
• Installing a head shim lowers your overall compression ratio. This lower compression causes a decrease in performance. You will have less bottom end and build boost slower. To make up for the loss of power you then need run higher boost. This increase in boost pressure increases charge air temps causing your system to be less efficiant and more prone to detonation.

Easy bolt on kit

• No major modifications to the chassis or engine needed. Control box has pre-programmed fuel maps so no need to dyno tune. Ready to ride right out of the box.

• Adjustable clutch kit

• You only need to buy one clutch kit to run 6-12+ PSI boost. As you turn up your boost simply add washers to the clutch weights to support the extra HP.